|
|
Yea, same here - I have 2 RaspTankPro's they both reset when the webServer.py starts up.
Used another pi to edit the "Startup.sh" program and comment it out. Then i tested each component separately.
Seems there is a problem with one or two of the servos? Also getting an error when the lights start up on the second Tank
(recently purchased from Amazon here in the UK, strange the base was already assembled - but had to get the screws undone
to get the plate off, like machined on). Anyway I have managed to actually get the first tank to work - the first time i assembled it -
but stupidly i wanted to control it with a PS4 controller so i tried adding some code - messed up the whole operating system.
So I re-do the memory card again - this time the tank left track moves all the time - cannot get it to work properly now.
They just seem very delicate and so is Linux - as a newbie! I wish Adeept would actually admit there are failings and have a special blog about
fixing issues. Would love to get them to work again.
setup steps, make sure the servos are not too tight and not tape the wires to the motors like i did before.
It worked ! I stupidly had the tank on a table and it fell off, but at least i was able to get something to work. |
|
Post time 2022-12-29 08:09:33