|
|
Hello,
I installed the OS on the Raspberry, connected to it via SSH and installed the dependencies to run the webserver.py program, but once I run it, it stops at Starting camera thread and never does anything else. No errors, nothing.
I tried a command that you can see a little higher up on the screen to see the status of the camera, there's 0 on detected, I figure the camera's not plugged in properly but I plugged it back in and I get a red light when I run the code on the camera, so logically it's powered up.
I don't know what to do, if someone can help me please.
|
|
Post time 2024-10-16 22:48:58
