|
|
Edited by 1616851264 at 2021-5-1 10:37 PM
Hi,
After searching for a while why my Raspberry Pi wifi broke down everythime in my AWD robot, I figured out that the screws for the servo are scratching up the wlan controller.
They are pretty long and when you turn tight, they start scratching the Pi board.
See 2nd image
Is it possible to get smaller screws? Or should I just saw the of a little bit?
Also during working on the AWD robot, the stand for my camera broke off.
Is it possible to get a replacment part?
See 1st image.
Thank you.
|
-
Camera stand
-
Pi board
|
Post time 2021-5-1 20:01:52