Drivers?

1737318237

Hi

I have several arduino unos and nanos and can succesfully connect.

However it does not recognise the adeept PCB? I can not connect to it when selecting ?

I have installed the CH341 driver via the app.

I also tried uninstalling and re installing the driver. It confirms successfully pre installed in advanced?

Any suggestions?

Thank you

1737318237

I have clicked again install and it "installs" but when clicking remove it says no device?

1737318237

Any ideas?

1738743990

If you've already installed the CH341 driver, here are a couple of things you can try:

Check Device Manager: Open Device Manager (on Windows) and see if your Adeept PCB is showing up under 'Ports (COM & LPT)' or 'Other Devices'. If you see a yellow triangle or error, right-click to update or reinstall the driver manually.

Try a Different USB Cable or Port: Sometimes the issue can be with the USB cable or port itself. Try a different one just to rule that out.

Check the Board’s Bootloader: Make sure the Adeept board has a working bootloader. Without it, the board won’t be recognized properly.

Manual Driver Installation: You can try manually installing the driver through Device Manager by navigating to the CH341 driver location on your system (if you have it saved) and pointing it to the folder during installation.

Windows Settings: If you’re on Windows 10/11, sometimes Windows automatically installs a different driver. You may need to disable automatic driver updates or force the system to use the specific CH341 driver.